Bauer LINESTAR 9000, Operating Manual

Page: 49 / 115

Operating Manual for BAUER LINESTAR 9000 with hose feed
41
Make sure that the main switch is in position „0“ Lock the switch against unintentional
re-closing or lock the door of the control box.
First of all the system must be perfectly aligned before the adjustment of the alignment control is to be started.
Then adjust the switch cam by winding the screws on the threaded rod until the roller of the control switch is
touching notch „A“ just in the middle between the switching point and the reversing point (
in between both clicks ).
This guarantees the same control angles in FORWARD and REVERSE run.
Adjust the micro switches as follows:
1.
Twist the control cam by turning the hexagonal nut on the threaded rod until the
control switch touches notch „A“ and responds.
2. Rotate the control cam clockwise up to the reversing switch point ( click ) of the
control switch, count the number of rotations of the nut or the turns with the
wrench.
3. Wind back the control cam by half of the counted nut or wrench turns to make the switch roller rest exactly in the
middle between switching and reversing point of the control switch.
4. Fix the adjustment nut with the lock nut on the
threaded rod. Adjust the two other nuts in such a
way to preload the spring by about 10 mm.
15.8 CHECKING ALIGNMENT
The LINESTAR is best aligned, if the system is forming a slight regular forward bow in both travel directions.
If this is not the case, realign the system as follows:

Turn main switch to position “1”

Start generator unit

Turn safety circuit switch to “ON”

Turn „LINESTAR“ switch to “ON”

Control panel LINESTAR PRO / PRO-G

Press “ENTER” key ( Menu ), the cursor starts blinking

Press “+“ and “-“ keys to set „LINEAR” mode

Confirm with “ENTER” key

Press “ESC” to exit programming mode
ATTENTION!