Bauer LINESTAR 9000, Operating Manual

Page: 51 / 115

Operating Manual for BAUER LINESTAR 9000 with hose feed
43
15.9 MACHINE OFFSET FROM LINEAR GUIDANCE
If the linear guidance components (
skid, cable roll, below ground antenna ) of the LINESTAR are situated at too far
a distance from the linear guidance ( cable, furrow, below ground cable ) after assembly, the system will not start
properly because the safety circuit is broken.
15.9.1 ALIGNMENT OF THE MACHINE WITH FURROW / CABLE GUIDANCE
1. Connect the safety circuit by bringing the respective
control lever of the linear guidance ( skid or
correction lever ) back to the normal position.
2. - Start the generator unit
- Move the main switch to position "1"
- Move the "Safety circuit ON-OFF" switch to the
position
"ON"
- Move the "LINESTAR OFF-ON" switch to
"ON"
On the LINESTAR PRO / PRO-G control panel
- Press the button "ENTER ( Menu )", the cursor
begins to blink
- Use the "+/-" buttons to set the "LINEAR"
mode
- Confirm with the "ENTER" button
- Leave the programming mode with the "ESC"
button
- Press the "FORWARD" button, the LINESTAR
must start up "clockwise" ( forward )
- Or press the "REVERSE" button, the
LINESTAR must start up "anti-clockwise"
( reverse )
3. Manually guide the LINESTAR in the direction of
the linear guidance by moving the respective
control lever in the desired direction.
Take care not to move the lever too far, which
might interrupt the safety circuit.