Bauer LINESTAR 9000, Operating Manual

Page: 57 / 115

Operating Manual for BAUER LINESTAR 9000 with hose feed
49
17.5 STARTING THE LINESTAR IN OPERATING MODE “WHEEL SWIVELLING”
Conditions:

You have the LINESTAR with cable or furrow guidance.

The central unit must be positioned directly above the swivelling point.

The swivelling range must be clear of weeds or obstacles.

The tracks which are to be crossed must not be deeper than 100 mm.

Remove guidance cable from clips around towers ( cable guidance )

Disconnect supply hose from central unit.

Flip up skids of furrow guidance and attach to central unit.

Disconnect the supply hose from the central tower.

Fold up the skids of the furrow guidance and affix them to the central tower.

Put switch “GENSET OFF - ON“ to „OFF“

Start the generator unit

Turn main switch to position „1“

Put switch “LINESTAR OFF - ON“ to „ON“.
Control panel LINESTAR PRO / PRO-G

Press „ENTER ( MENU )” key, the cursor starts blinking

Select mode „WHEEL SWIVELLING“ with „+/-“ keys

Confirm with „ENTER“

Press „ESC“ to exit programming mode

Detach fixing device of drive console at wheel carrier.

Press one of the arrow keys to see which one of the motors gets started.

Press arrow keys „ FORWARD / REVERSE” to swing concerned wheel by 90°.

Fix wheel with wheel brace.

Press both arrow keys of control box simultaneously to skip to second motor.

Press arrow keys of control box to swing second wheel by 90°

Fix with wheel brace.

Remove driving pin of gearbox ( freewheel ).
17.6 STARTING THE LINESTAR IN OPERATING MODE “PIVOTING”