Baroness GM1700, Service Manual

Page: 156 / 192

Drive the wheel evenly into the bearing
attached to the shaft.
1
8i4lkm-006
Inspection of Left and Right Wheels of Center
Deck_006
1 Wheel
Insert the collar into the shaft of the
bracket.
1
8i4lkm-007
Inspection of Left and Right Wheels of Center
Deck_007
1 Collar
Drive the bearing into the wheel evenly.
Note:
The bearing can be inserted deeper
inside beyond the upper face of the
wheel.
2
1
8i4lkm-008
Inspection of Left and Right Wheels of Center
Deck_008
[4]
[5]
[6]
1 Bearing
2 Driver
Insert the washer and wheel tightening
washer into the shaft of the bracket and
tighten them with the bolts and spring
washers.
Make sure that the wheel rotates
smoothly.
Follow the same steps to complete the
installation on the opposite side by the
same procedure.
3
1
2
8i4lkm-001
Inspection of Left and Right Wheels of Center
Deck_009
1 Bolt and spring washer
2 Wheel tightening washer
3 Washer
Inspection of Rear Wheel of Center Deck
Wear of bearing due to frequent use and/or
damage of bearing etc. caused by invasion
of water may prevent smooth rotation of the
rubber wheel. Inspect and replace the parts
such as the bearing.
Make sure that there is no abrasion or
adhesion of the rubber wheel.
Make sure that there is no wear of the
wheel shaft of the bracket.
Make sure that the bracket is not cracked
or bent.
Make sure that there is no wear of the
collar, bolt, or washer etc.
Make sure that there is no wear or rusting
of the bearing.
Make sure that there is no play in the fit of
the wheel shaft of the bracket and the
bearing.
[7]
[8]
[9]
￭
･
･
･
･
･
･
GM1700
Operating Machine and Mower Units
Page 7-40
Contour Deck