Baroness GM1700, Service Manual

Page: 130 / 192

Remove the bolt and then remove the
washer and pulley.
1
3
2
fyj6de-002
Removal of Left and Right Deck Housing_002
1 Bolt
2 Washer
3 Pulley
Remove the key from the rotary shaft.
Remove the six bolts.
1
2
3
3
fyj6de-003
Removal of Left and Right Deck Housing_003
1 Rotary shaft
2 Key
3 Bolt
Remove the housing.
fyj6de-004
Removal of Left and Right Deck Housing_004
5.
6.
7.
8.
Installation of Left and Right Deck Housing
Caution
See the " "Tightening torques" (Page 3-6) "
list.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening, etc.
For installation, reverse the removing
procedure.
Tighten bolts A and B alternately to install
the housing.
3
1
1
1
2
m2199u-002
Installation of Left and Right Deck Housing_001
1 Bolt A
2 Bolt B
3 Housing
Removal of Center Deck Housing
Remove the mower unit from the main
body. (See "Removal of Mower Unit"
(Page 7-9) .)
Remove the rotary knife. (See "Change
of Rotary Knife" (Page 7-24) "Contour
Deck" (Page 7-10) .)
Remove the belt. (See "Removal of Belt"
(Page 7-12) .)
Raise the mower unit with a hoist and
place the jack stand to secure it.
Caution
Drive in the knife mounting bolt while the
mower unit is stable.
Install the knife mounting bolt to the
center knife shaft.
Drive in the knife mounting bolt with a
wooden hammer until it hits the knife
mounting bracket.
1.
2.
1.
2.
3.
4.
5.
6.
GM1700
Operating Machine and Mower Units
Page 7-14
Contour Deck