Baroness GM1700, Service Manual

Page: 62 / 192

Remove the taper plug w/hexagon hole
from the hydraulic fitting.
1 2
7edlvx-024
Reverse_002
1 Hydraulic fitting
2 Taper plug w/hexagon hole
Caution
Use a pressure gauge and hydraulic hose
which can withstand the pressure of 20.6 MPa
(2,987.67 psi) or more .
Follow the steps below to install the
pressure gauge for high pressure
measurements to the main body.
Install the adapter in the portion where
the taper plug w/hexagon hole is
removed.
Tentatively install the pressure gauge
for high pressure measurements on the
adapter.
1
2
10
20
30
15
25
35
5
7edlvx-025
Reverse_003
1 Adapter
2
Pressure gauge for high pressure
measurements
1.
2.
[1]
[2]
Tighten the hydraulic hose so that the
installed hydraulic hose does not touch the
moving parts.
10
20
30
15
25
35
5
1
7edlvx-026
Reverse_004
1
Pressure gauge for high pressure
measurements
Apply resistance on the machine using a
sling, etc. to the frame of this machine.
1
7edlvx-022
Reverse_005
1 Sling installation position
Make sure that the parking brake is
applied.
Make sure that the 2WD/4WD changeover
lever is set to the 4WD position.
Start the engine, and rev it up to the
maximum rpm.
It is normal if the pressure becomes 20.6
MPa (2,987.67 psi)when the reverse pedal
is depressed and the tires are locked
without slipping.
3.
4.
5.
6.
7.
GM1700
Hydraulic system
Page 4-34
Measurement