Baroness GM1700, Service Manual

Page: 58 / 192

Remove the hydraulic hose of the reverse
swivel joint of the right wheel motor of the
front wheel.
3
1
2
7edlvx-019
Reverse_002
1 Wheel motor
2 Swivel joint
3 Hydraulic hose (reverse)
Caution
Use a pressure gauge and hydraulic hose
which can withstand the pressure of 20.6 MPa
(2,987.67 psi) or more .
Follow the steps below to install the
pressure gauge for high pressure
measurements to the main body.
Tentatively install the 9 hydraulic hose
onto the swivel joint with the hydraulic
hose removed.
Tentatively install the adapter 9 to the
removed hydraulic hose.
10
20
30
15
25
35
5
1 2
4
3
5
2
7edlvx-020
Reverse_003
1 9 hydraulic hose
2 Adapter 9
3 Adapter 6
4 T-joint
5
Pressure gauge for high pressure
measurements
1.
2.
[1]
[2]
Tighten the hydraulic hose so that the
hydraulic hose does not touch the tire
even if the handle is operated.
10
20
30
15
25
35 5
1
3
2
7edlvx-021
Reverse_004
1 Hydraulic hose
2 Hydraulic hose (reverse)
3
Pressure gauge for high pressure
measurements
Apply resistance on the machine using a
sling, etc. to the frame of this machine.
1
7edlvx-022
Reverse_005
1 Sling installation position
Make sure that the parking brake is
applied.
Make sure that the 2WD/4WD changeover
lever is set to the 4WD position.
Start the engine, and rev it up to the
maximum rpm.
It is normal if the pressure becomes 20.6
MPa (2,987.67 psi) when the reverse
pedal is depressed and the tires are
locked without slipping.
3.
4.
5.
6.
7.
GM1700
Hydraulic system
Page 4-30
Measurement