Baroness GM1700, Service Manual

Page: 164 / 192

Place the relay pulley on the vise with the
side where the stop ring was installed
facing downward to secure space for the
bearing to come out.
Remove the bearing by hitting it from front
to back and from side to side alternately
with a wooden hammer using an iron pipe.
Follow the same steps to remove the
bearing from the other side.
2
1
5yhx8g-005
Inspection of Relay Pulley Stage Comp_005
1 Relay pulley
2 Iron pipe
Follow the steps below to install the
bearing onto the relay pulley.
5.
6.
7.
8.
Important
Be sure to replace the bearing with new one.
Important
The bearing is a double-sealed one.
Be careful not to scratch the seal of the main
body of the bearing when tapping it.
Drive the bearing into the relay pulley
evenly.
Note:
Use a bearing driver to drive in the
bearings and oil seals.
3
2
1
5yhx8g-006
Inspection of Relay Pulley Stage Comp_006
1 Relay pulley
2 Bearing
3 Driver
Install the stop ring onto the relay pulley.
Then drive the bearing into the opposite
side.
Attach the stop ring.
1
2
5yhx8g-007
Inspection of Relay Pulley Stage Comp_007
1 Stop ring
2 Relay pulley
[1]
[2]
[3]
[4]
GM1700
Operating Machine and Mower Units
Page 7-48
Contour Deck