Baroness GM1700, Service Manual

Page: 112 / 192

Adjusting the Neutral Position of the Piston
Pump
Caution
Make sure not to touch rotating tires.
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Place the jacks beneath the jack-up
points, and then lift the machine off the
ground.
Use stable jack stands, and raise the
machine until the tires lift off the ground.
(See "Jack-up Points" (Page 3-11) .)
Remove the seatback cover on the right
side.
Remove the underseat cover on the right
side.
Start the engine, and rev it up to the
maximum rpm.
Set the 2WD/4WD selector switch to the
"4WD" position.
Adjust the neutral position for the rear
wheels.
If the rear tires rotate forward, loosen
the cam lever shaft, and then adjust lock
nuts A to move the shaft seat backward.
Find the position where the rear wheels
stop, and then tighten the cam lever
shaft to secure it.
If the rear tires rotate in reverse, loosen
the cam lever shaft, and then adjust lock
nuts A to move the shaft seat forward.
Find the position where the rear wheels
stop, and then tighten the cam lever
shaft to secure it.
5
6
1
4
3
2
hsn2jo-009
Adjusting the Neutral Position of the Piston Pump_001
￭
1.
2.
3.
4.
5.
6.
7.
[1]
[2]
1 Cam lever
2 Cam lever shaft
3 Shaft seat
4 Lock nut A
5 Threaded rod
6 Lock nut B
Important
Before adjusting the neutral position for the
front wheels, make sure that the rear wheels
have first been set to the neutral position.
Adjust the neutral position for the front
wheels.
If the front tires rotate forward, loosen
lock nuts B of the threaded rod, then
turn the threaded rod to shorten the
connection.
Find the position where the front wheels
stop, and then tighten lock nuts B.
If the front tires rotate in reverse, loosen
lock nuts B of the threaded rod, then
turn the threaded rod to extend the
connection.
Find the position where the front wheels
stop, and then tighten lock nuts B.
5
6
1
4
3
2
hsn2jo-009
Adjusting the Neutral Position of the Piston Pump_002
1 Cam lever
2 Cam lever shaft
3 Shaft seat
4 Lock nut A
5 Threaded rod
6 Lock nut B
8.
[1]
[2]
GM1700
Main body
Page 6-8
Adjustment