Barco SIM 7Q, User Manual

Page: 56 / 290

5. Setup
5.5 Setting the projector address (only if necessary)
What can be done ?
The projector is shipped with projector address set to ”0”
In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-
pendently).
In the OSD menu Projector Address , the following addresses can be programmed :
• Projector address: address de fi ned by the user, may be from 0 to 255
0-9 is used for RCU communication
• Common address : address may be 0 or 1
How to change the projector’s address ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Projector address
Image 5-6
5. Press ENTER
A dialog box appears on the screen
Image 5-7
6. Enter the new projector address with the digit keys on the RCU, the local keypad or the cursor keys.
How to change the common address ?
1. Proceed in the same way as for the projector address
52 R59770066 SIM 7Q SERIES 07/10/2013