Barco R9050100, User Manual

Page: 175 / 233

16. Servicing
16. SERVICING
About this chapter
This chapter contains general servicing procedures like lamp replacement, input unit replacement etc. Note that some of these
procedures may only be performed by quali
fi ed technical service personnel. These procedure are marked with a warning.
Extra service information
Extra service information for quali fi ed service technicians can be found on Barco’s Partnerzone (URL: www.partner-
zone.events.barco.com ). Registration is necessary.
If you are not yet registered, click on Partnerzone registration and follow the instructions. With the created login and password, it is
possible to enter the partnerzone where you can
fi nd extra service information about the projector.
HEPA
High Ef fi ciency Particulate Absorbing
Overview
• Replacement of the dust fi lter on the top side
• Replacement of the dust fi lters on the front side
• Lens installation
• Lens removal
• Removal of a lamp unit
• Mounting a new lamp unit
• Removal of an input module
• Inserting an input module
• Top-up the reservoir with cooling liquid
C
AUTION
:
All HEPA fi lters of the projector must be replaced on a regular basis, depending on the environment
conditions of the projector.
16.1 Replacement of the dust fi lter on the top side
All dust fi lters in the projector are identical.
Necessary parts
New HEPA dust fi lter.
How to replace the fi lter on top of the projector
1. Switch off the projector and unplug the power cord from the wall outlet.
2. Remove the lamp door, see "Removal of the lamp door", page 184.
3. Take the fi lter on the side parallel with the cover and pull it upwards (A). Pivot it a little and take it out (B).
R59770021 CLM R10+ 15/03/2010 171