Barco R9050100, User Manual

Page: 47 / 233

5. Connections
USB port
The communication interface is equipped with a master USB port, type “A” connector (H). This USB port will simplify the service
procedures for software updates or for taking backup
fi les from the projector without network connection. An USB-stick is plugged
into the USB port and fi les can be transferred from or to the projector using the local or remote control unit. Note that the USB-stick
has to be Linux FAT16 compatible.
DMX interface
The communication interface of the CLM R10+ supports DMX.
DMX is used as communication bus between different devices in the light technic. Each device has an input and an output, so that
the bus can be looped between the different devices. According the standard a
fi ve wire cable with XLR connector is used but mostly
3-wire cables are used.
You can use the DMX input port (G) to connect a DMX device to the CLM projector. This way you can control the CLM projector
from that DMX device. The DMX output port (G) can be connected with the next device in the loop.
Pin Description
1 Earth
2 Cold
3 Hot
4
Return - (or not used)
5 (or not used)
DMX
DMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a lighting controller to
lighting devices. Standardized by USITT.
R59770021 CLM R10+ 15/03/2010 43