5. Advanced
Image 5-31
2. Press
Enter
to con
fi
rm the selection. The Passive In
fi
tec
fi
lter moves out of the light path.
Note:
It takes some time before the Passive In
fi
tec
fi
lter has fully moved out of the light path.
5.4.7
Passive to Active Stereo
Introduction
If your Galaxy NW projector has two dual link DVI input boards present, the projector can be used to convert Passive Stereo images
(i.e. separate signals for Left
fi
eld and Right
fi
eld) into an Active Stereo image.
Overview
•
Passive to active stereo conversion
•
Combining passive stereo inputs into an active stereo image
5.4.7.1
Passive to active stereo conversion
Description
From projector
software version 3.04
on, it is possible to combine two passive stereo input signals and display an active stereo
image. One of the input signals presents the right image content, while the other input signal presents the left image content.
Input signal requirements
The input signals must meet some speci
fi
c requirements:
•
only
DVI
input signals are supported
•
the input signals must each be connected to a
different input layer
on the projector
•
to avoid image artifacts, both input
signals must be identical
(resolution, timing-format, ...) and externally
frame-locked
Active image features and restrictions
Both input signals are displayed on top of each other, as two full screen images (or full screen “PiP’s) exactly aligned onto each
other. This implies that only one of the displayed images can be selected at a time (e.g. to change Contrast). By default the selected
image is the input signal linked to
Source 1
in the
Passive to Active Stereo Con
fi
guration
dialog box. It is possible to select the other
image by pressing the
PiP Adjust
button on the RCU.
This is important because:
•
changing image settings (e.g. Contrast, Brightness, Gamma, ...) is only applied to the selected image;
•
the sync of the selected image is used to display
Scaled Patterns
.
5.4.7.2
Combining passive stereo inputs into an active stereo image
How to de
fi
ne the Right and the Left input signal?
1. Connect each active stereo DVI input signal to a different input layer on the projector.
2. Check the presence of the input signals in the
Source selection
menu: select a different source (e.g.
L1 PC
). A Barco logo is
visible in front of both corresponding DVI input connectors if the signals are present and detected.
R59770718 GALAXY NW SERIES 20/06/2013
67
Summary of Contents for R9040411
