Barco R9040411, User Manual

Page: 30 / 209

2. Installation
DVI DVI DVI DVI 1 2
DESKTOP INPUT DESKTOP INPUT
IN1 IN1 IN2 IN2
L1 L1
STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT
L2 L2 L3 L3
IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
RS 232 C RS 232 C DVI DVI R.C. R.C.
Image 2-23
Desktop input
Tip: An Ethernet connection must also be set to allow Desktop integration
The projector can be connected to a LAN or can be connected to a desktop PC via a crossed cable (as indicated
above).
The desktop can be enabled/disabled, "Desktop", page 117
Using the desktop input makes only sense when using the Barco Desktop integration software. The Desktop
integration software is covered in the Desktop integration User Guide.
2.7.5 DVI output
DVI output
DVI DVI DVI DVI 1 2
DESKTOP INPUT DESKTOP INPUT
IN1 IN1 IN2 IN2
L1 L1
STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT
L2 L2 L3 L3
IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
RS 232 C RS 232 C DVI DVI R.C. R.C.
Image 2-24
DVI output
The DVI output is a single link DVI output signal, having the following speci fi cations:
• resolution: is the same as the native resolution of the projector;
• vertical refresh rate: 60 Hz if the projector runs in asynchronous mode mono;
• signal type: digital signal (DVI).
It re fl ects the projected image, excluding Geometry corrections, Soft edge and Black level correction, Dynacolor settings and OSD.
C
AUTION
:
If the projector runs in synchronous mode, the DVI output is synchronous with the input signal.
In this mode, most monitors will not display the signal in a correct way!
24 R59770718 GALAXY NW SERIES 20/06/2013