R9001440/9
GRAPHICS
Panel Adjustments
Date:10/02/2000
6300
6
Panel Adjustments
Connection of the TCR
tracker unit
Install the TCR Tracker unit, as illustrated in
drawing below. Make sure that the switch on
the TCR Interface is put in the position OFF
and that the projector is switched to Standby.
TCR Tracker
Detailed view of the TCR Tracker
and interface, see next page
TCR Interface
Screen
Projector
from Sensor
to RS232 IN
projector
to COMM PORT
projector
Change Projector Address
Every projector requires an individual address
between 0 and 255. This address can be
software installed.
To change that address:
1
Push the cursor key
é
or
ê
to highlight
'Change Projector Address''.
2
Press
ENTER
to display the
Change
Projector Address
menu. The actual
address will be filled in.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
DIMMING
MORE ...
CHANGE PROJ. ADDRESS
Enter new address
001
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
DIMMING
MORE...
Select with or
then <ENTER>
<EXIT> to return.
Change Baudrate PC
The communication speed between projector
and computer, e.g. PC or MAC, has 8 possible
speeds. The baud rate speed can be software
set. Handle as follow:
1 Push the cursor key
é
or
ê
to highlight
'Change Baudrate PC''.
2 Press
ENTER
to display the
Change
Baudrate PC
menu. The actual baudrate
will be highligted.
The following baud rates are available :
230400/115200/57600/38400/19200/9600/
4800/1200
3 Push the cursor key
é
or
ê
to highlight the
baudrate 9600 and press
ENTER
to select.
Select with or
<ENTER> to accept
<EXIT> to return.
CHANGE BAUDRATE PC
230400
115200
57600
38400
19200
9600
4800
1200
Set the projector address on 001 as follows:
The first digit is highlighted. Enter the new projector address with :
- the digit keys on the RCU or the local keypad or
- push the cursor key
ç
or
è
to select a digit and change the value by pushing
the cursor key
é
or
ê
until the new value is reached. Continue with the other
digits on the same way.
