System manual ImageTile
62
If necessary detach the second display of the BarcoMed 3MP2FH
Imaging Board you are working with by right clicking on the
rectangle that represents it and deselect “Attached”. Click the
“Apply” button.
Note: Since Windows 2000 will not let you detach the primary
display, you may need to temporarily make another display the
primary display.
3. For the display which is still attached click on the “Advanced”
Button.
4. Select the “Adapter” tab and then click on the “List All Modes…”
button. Select the resolution and refresh rate that your ImageTile
display panel supports from the dialog box and click “OK”.
Note: In the Adapter box, the Adapter string shows if this display is
the First View or the Second View attached to the Imaging Board.
Please make a note of this, so that you can arrange the displays in
the correct order later.
5. Click “OK” on the bottom of the Adapter Control Panel. If the
“OK” button on the bottom of the Adapter Control Panel is not
visible, press “CTRL”+“Enter” to select “OK”.
6. Click “OK” in the “Windows will now apply your new desktop
settings” dialog box. Your high resolution display(s) should now
synchronize and display the Windows desktop.
7. Click “Yes” when asked, “Your desktop has been reconfigured.
Do you want to keep these settings?”
To set the resolution of the second ImageTile display panel attached
to the BarcoMed 3MP2FH Imaging Board you are working with, go
back to the “Settings” tab of the “Display Properties Control Panel”.
Attach the display you detached in step 2 above, by right clicking on
the rectangle that represents it and selecting “Attached”.
Now repeat steps 3 – 7 above for this display.
If you are using a Quad-Head Configuration repeat all of the above
steps for the two displays on the second imaging board.
Special note: After installing DualView and setting the resolutions in a
Quad-Head Congifuration you may need to drag the heads into the
proper position in the window on the “Settings” tab, so that the
arrangement in the window on the “Settings” tab matches the
physical arrangement of your configuration.
After installing DualView use the Barco Metheus Configuration Control
Panel to verify or change your system settings.
BarcoMed software driver installation
Summary of Contents for IMAGETILE
