System manual ImageTile
61
6. In the “Find New Hardware” page of the wizard select the radio
button beside “No, I want to select the hardware from a list” and
click “Next”.
7. In the “Hardware Type” page of the wizard, highlight “Display
Adapters” and then click “Next”.
8. In the “Select a Device Driver” page of the wizard select “BARCO
Metheus” in the Manufacturers column and “BarcoMed
3MP2FH” in the Models column. Click “Next”.
9. The “Start Hardware Installation” dialog box appears. Click
“Next”.
10. Windows will warn you that a digital signature was not found. Click
“Yes” to continue the installation. .
11. When the drivers have finished copying, click “Finish” on the
“Completing Found New Hardware Wizard” page to complete the
installation.
12. Windows may now prompt you to reboot your system. Click
“Yes”. Boot normally and log in using an account with
administrator privileges.
Repeat steps 1 – 12 above for each 3MP2FH board for which you
want to have the DualView feature enabled.
Setting the Resolution of Your ImageTile Display Panel with
DualView enabled
Once you have completed the installation of the separate screens with
DualView, you need to set the resolution for each display. Both
screens of each imaging board cannot be enabled at the same time
unless their display properties match.
1. To set the resolution for your ImageTile display panel(s) under
DualView, right click on the desktop and select “Properties”.
2. Select the “Settings” tab (see figure 33 earlier in this chapter).
Now select the rectangle that represents the first ImageTile
display panel attached to the BarcoMed 3MP2FH Imaging Board
you are working with.
SPECIAL NOTE: If you are using the VGA capabilities of your
BarcoMed 3MP2FH Imaging Board, the resolution for the first
display will still be set to a VGA resolution of “640 x 480” pixels. If
the BarcoMed 3MP2FH Imaging Board is not running VGA, the
display may not be enabled yet. To enable the device check the
“Extend my Windows desktop onto this monitor” checkbox.
Do not click the “Apply” button at this time.
BarcoMed software driver installation
Summary of Contents for IMAGETILE
