System manual ImageTile
50
Figure 27
Setting the Resolution of Your ImageTile Display Panel with
DualView Disabled
1. To set the resolution for your ImageTile display panel(s), right click
on the desktop and select “Properties”. Select the “Settings”
tab (see Figure 28 on the next page). Now select the rectangle
that represents the BarcoMed 3MP2FH Imaging Board you are
working with.
SPECIAL NOTE: If you are using the VGA capabilities of your
BarcoMed 3MP2FH Imaging Board, the resolution for that board
will still be set to a VGA resolution of “640 x 480” pixels. If the
BarcoMed 3MP2FH Imaging Board is not running VGA, the device
may not be enabled yet. To enable the device check the “Extend
my Windows desktop onto this monitor” checkbox. Do not click
the “Apply” button at this time.
2. Click on the “Advanced” Button.
3. Select the “Adapter” tab and then click on the “List All Modes…”
button. Select the desired resolution and refresh rate that your
ImageTile display panel supports from the dialog box and click
“OK”.
Note: The resolutions shown will be based on the number of
heads the imaging board supports.
For example: The BarcoMed 3MP2FH Imaging Board
supports two ImageTile display panels. If the resolution of
each display is 1536x2048x256, Windows 2000 will display
the resolution as 3072x2048x256. If necessary you can
change the number of display panels later by using the
Barco Metheus Configuration Tab.
BarcoMed software driver installation
Summary of Contents for IMAGETILE
