System manual ImageTile
52
Setting the Resolution of Your ImageTile Display Panel with
DualView enabled
Once you have completed the installation of the separate screens with
DualView, you need to set the resolution for each display. Both
screens of each imaging board cannot be enabled at the same time
unless their display properties match.
1. To set the resolution for your ImageTile display panel(s) under
DualView, right click on the desktop and select “Properties”.
2. Select the “Settings” tab (see figure 33 earlier in this chapter).
Now select the rectangle that represents the first ImageTile
display attached to the BarcoMed 3MP2FH Imaging Board you are
working with.
SPECIAL NOTE: If you are using the VGA capabilities of your
BarcoMed 3MP2FH Imaging Board, the resolution for the first
display will still be set to a VGA resolution of “640 x 480” pixels. If
the BarcoMed 3MP2FH Imaging Board is not running VGA, the
display may not be enabled yet. To enable the device check the
“Extend my Windows desktop onto this monitor” checkbox.
Do not click the “Apply” button at this time.
If necessary detach the second display of the BarcoMed 3MP2FH
Imaging Board you are working with by right clicking on the
rectangle that represents it and deselect “Attached”. Click the
“Apply” button.
Note: Since Windows 2000 will not let you detach the primary
display, you may need to temporarily make another display the
primary display.
3. For the display which is still attached click on the “Advanced”
Button.
4. Select the “Adapter” tab and then click on the “List All Modes…”
button. Select the resolution and refresh rate that your ImageTile
display panel supports from the dialog box and click “OK”.
Note: In the Adapter box, the Adapter string shows if this display is
the First View or the Second View attached to the Imaging Board.
Please make a note of this, so that you can arrange the displays in
the correct order later.
5. Click “OK” on the bottom of the Adapter Control Panel. If the
“OK” button on the bottom of the Adapter Control Panel is not
visible, press “CTRL”+“Enter” to select “OK”.
6. Click “OK” in the “Windows will now apply your new desktop
settings” dialog box. Your high resolution display(s) should now
synchronize and display the Windows desktop.
7. Click “Yes” when asked, “Your desktop has been reconfigured.
Do you want to keep these settings?”
BarcoMed software driver installation
Summary of Contents for IMAGETILE
