Barco IMAGETILE, System Manual

Page: 57 / 135

System manual ImageTile 58
5. Select the radio button beside “Display a list of the known drivers
for this device so that I can choose a specific driver”. Click
“Next”.
6. In the “Hardware Type” page of the wizard, highlight “Display
Adapters” and then click “Next”.
7. In the “Select a Device Driver” page of the wizard click “Have
Disk”. Insert your ImageTile Software CD or browse to the
location of your driver and Click “OK”.
8. Select “BarcoMed 3MP2FH “ in the “Select a Device Driver”
window. Click “Next”.
9. The “Start Device Driver Installation” dialog box will appear. Click
“Next”.
10. Windows will warn you that a digital signature was not found. Click
“Yes” to continue the installation.
11. When the drivers are installed, click “Finish” on the update driver
wizard and click “Close” on the properties page for the device.
Reboot your system when asked, even if you are reinstalling or
updating the drivers for multiple BarcoMed 3MP2FH boards in your
system .
12. Boot normally and log in using an account with administrator
privileges. Repeat steps 1-12 until you have reinstalled or updated
the drivers for all of the BarcoMed Imaging Boards.
Setting the Resolution of Your ImageTile Display Panel
To set the resolution of your ImageTile Display Panel see the section
“Setting the Resolution of Your ImageTile Display Panel with DualView
Disabled” earlier in this chapter.
For more information about DualView and how to install it proceed to
the next page.
BarcoMed software driver installation