![background image](http://html1.mh-extra.com/html/barco/id-h250/id-h250_service-manual_3858134046.webp)
5. Electronic spares and servicing procedures
2. Push the cursor key
←
or
→
to highlight
Installation
in the menu bar.
3. Push the
↓
key to pull down the
Installation
menu.
4. Push the cursor key
↑
or
↓
to highlight
Network settings
and press
ENTER
to select.
Image 5-25
A dialog box will be displayed.
Image 5-26
5. Push the cursor key
↑
or
↓
to highlight the desired parameter.
6. Use the cursor key
←
or
→
, the numeric keys on the RCU, or the local keypad, to edit and change the values.
7. Press
Apply settings
to apply the changes
A dialog box is shown. The different executed operations are shown with a checkbox. The last operation
Restarting network
takes a few seconds more.
Image 5-27
5.4.3.6.3
Diagnostics of the ethernet board
Diagnostic LEDs
There are two indication LEDs:
•
left LED (orange): ON during TX activity (transmission only)
•
right LED (green): ON when a link is established
Image 5-28
ethernet connector: indication LEDs
5.4.3.6.4
Replacing the ethernet board
Necessary tools
Torx screwdriver T10
How to replace the ethernet board?
1. Remove the input module form the projector
2. Remove the backplane
3. Remove the side screw
42
R59770097 ID H250 / H500 15/05/2007
Summary of Contents for iD H250
