Barco F70 - 4K6, User Manual

Page: 48 / 136

601 – 426-03 F70 Series 48
4.1 Installation Process
Recommended Installation sequence
Item Procedure
Read more in chapter
1 Confirm that the installation area meets all
technical and environmental requirements See “ Installation conditions ” , page 48
2 Decide where the projector will be
mounted See “ Positioning the projector ” , page 49
3 Unpack the projector and confirm that all
equipment is present and in good working
order See “ Initial inspection ” , page 49
4 Mount the projector See “ Mounting the projector, general
considerations ” , page 50
5 Install the projector lens See “ Replace a lens ” , page 43
6 Connect the source See “ Projector source and control
connections ” , page 60
7 Power up the projector See “ Power up the projector ” , page 63
8 Set up the image See “ Image menu ” , page 75
4.2 Installation conditions
Environmental Conditions
Barco projectors are manufactured according to specific design standards, which also include
environmental conditions. Failing to follow the terms and conditions outlined in this chapter can
result in loss of product warranty
The table below summarize the physical environments in which the projector may be safely operated or
stored.
Environment
Ambient operating
temperature
Relative Humidity Storage condition
0 -500m +10 to +45 °C 10 – 80% RH – 20 to +60 °C, 10 – 90 %
RH
500 -1500m +10 to +40 °C 10 – 80% RH – 20 to +60 °C, 10 – 90 %
RH
1500 - 3000m +10 to +35°C 10 – 80% RH – 20 to +60 °C, 10 – 90 %
RH
Maximum Air Flow 900m 3 /hour 10 – 80% RH Not Applicable
Mains power requirement
Projector Power Requirement
F70 100 – 240V. 50 – 60 Hz.
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that
the instrument panel and cabinet be grounded.
In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a qualified electrician in conformance to local codes. Hardware, wire sizes
and conduit types must comply with local codes.
Ventilation
The free space necessary between the air intake and exhaust are shown below.
Physical Installation