Barco DP2K SLP Series, Service Manual

Page: 212 / 410

R5906848 /04 DP2K SLP Series 212
• Contains a real time clock, which must be synchronized with the GMT/UTC time stored in the link decryptor
module or Integrated Media Block (see Communicator software)
• Handles unpacking of special video formats
The ICP board spare part kit is not default programmed for a DP2K-SLP Series projector. When
using this board in a DP2K-SLP Series projector the software must be re-installed after installation
of the board.
When installing a new ICP board in a DP2K-SLP Series projector the Spatial Color Calibration file
must be reloaded and activated.
CAUTION: Make sure not to short circuit the battery on the board. That will destroy the board
completely !
18.3 Cinema Controller
Location of the communication ports
5 6 7 4 3 2 1
Image 18-2
Functionality
1
Diagnostic LEDs
The front plate of the Cinema Controller contains 4 diagnostic LEDs to display the status of the power
supply:
• +VTEC supply (not used on DP2K-S series projector).
• +24V supply.
• +12V supply.
• general power supply (ERROR).
2
USB IN port
The Cinema Controller is equipped with a USB port, type “ B ” connector to connect upstream devices (E.
g. PC). This USB port is used to communicate with the projector via RS232 commands (Virtual comport).
3
USB OUT port
The Cinema Controller is equipped with a USB port, type “ A ” connector which can be used to power
handheld devices within USB spec (MAX 500mA/5V]. No other functionality supported (Future
expansion).
4
3D INTERFACE
3D interface port can be used to connect external 3D devices to the projector. All signals necessary for
3D projection can be provided via this connector.
Card Cage