Barco Coronis MDCC 2121, Getting Started Manual

Page: 53 / 75

Installing drivers and software
53
7.
When the Setup complete message appears, select
Reboot
System Now
and click
Finish
.
8.
After the system reboots, Windows may display either the
Digital
Signature Not Found
message or
The software you are installing
for this hardware has not passed Windows logo testing to verify
its compatibility with Windows XP
message. If it does click
Yes
or
Continue
to complete the driver and software installation.
Automated display configuration
Once the drivers, software and documentation have been installed and
your system has been rebooted, the
Barco Monitor Plug and Play
Software
should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the
Barco Monitor
Plug and Play Software
fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section,
Setting
the resolution of your B
ARCO
C
ORONIS
Display
, on page 67 in the
Troubleshooting section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your B
ARCO
C
ORONIS
Display System
Installation CD-ROM, see
Installing the B
ARCO
MXRT drivers and
software
, on page 50 of this manual.
Uninstalling the drivers and software
To uninstall the Barco drivers, software or documentation for your Barco
Coronis Display Systems, please use the
Windows Add/Remove
Programs
utility. This can be found in the Windows Control Panel.
Note:
When uninstalling the Barco MXRT drivers, the devices
must be uninstalled in pairs. When the dialog box shown in
figure 26 appears select all of the devices listed.