Barco Coronis MDCC 2121, Getting Started Manual

Page: 41 / 75

Connecting the signal cables
41
Connecting the signal cables
To connect the signal cables to the display:
1.
Make sure the computer is turned off.
2.
To get access to the connectors, remove the connector
compartment cover (1).
To remove the cover, gently pull the bottom side of the cover
upward or firmly press down the 2 clips at the top side (positions
marked in the plastic).
3.
To facilitate cable routing afterwards, remove the tilt & swivel neck
cover (2). Therefore, first tilt the display panel in upright position.
Then lift and pull backward the neck cover.
4.
Also to facilitate cable routing afterwards, open both cable duct
covers (3).
Figure 20: Remove covers before connecting signal cables