Barco Coronis MDCC 2121, Getting Started Manual

Page: 28 / 75

Installing your Barco display controller
28
Quick installation
Experienced users and system administrators can follow these brief
instructions for installing the display controller(s) for your B
ARCO
C
ORONIS
Display System in the shortest possible time.
To perform a quick installation
1.
If you are not going to use your old graphics card, uninstall the
drivers and software for it if you have not already done so.
Note:
If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a multiple-
display setup, disable it either in the computer’s System Set-up
utility (BIOS) or the Windows device manager.
2.
Shut down and disconnect your computer system.
3.
If necessary, remove any previously installed graphics card.
4.
Install the display controller(s) for your B
ARCO
C
ORONIS
Display
System.
5.
Reassemble and connect your computer system.
6.
Install the drivers, QAWeb software and documentation for your
B
ARCO
C
ORONIS
Display System by following the instructions in the
section
“Installing drivers and software”
on page 50 of this
manual.
CAUTION –
Wear a
grounded
, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.