Region of Interest
Anchor Point (mm)
—Define the X, Y and Z points of the sensor region of interest. From the
Z(mm)
view (Image
Pane parameters), click the center of the container region of interest. Record the X(mm), Y(mm), and Z(mm) values
from the software. These represent the bottom of the container. Pay attention to positive and negative values.
Figure 16. Anchor Point Diagram
X-Axis
Y-Axis
Z-Axis
(
X
,
Y
,
Z
)
X = Center X point of container
Y = Center Y point of container
Z = The Z measurement from the bottom, or furthest point, of
the container
Size (mm)
—Define the length, width, and height of the container region of interest. The entire region of interest
should be contained within the walls of the container.
Figure 17. Dimensions Diagram
Y-Width
X-Length
Z-Height
X = X-Length size dimension
Y = Y-Width size dimension
Z = Z-Height of container or desired detection limit
Sensor Controls
Limits—Fill Level
: The threshold percentage that activates the Fill Level Limit Output.
Limits—Peak Height
: The threshold height, in millimeters, that activates the Peak Height Limit Output.
Output #1 Control
and
Output #2 Control
—The desired sensor outputs being exported; for more information, see
on page 17.
Disabled
DOUT = Fill Percent
DOUT = Peak Height
DOUT = Fill or Peak
Pulse Pro = Fill Percent
Pulse Pro = Peak Height
Output 2 is disabled when the external trigger is enabled."External Trigger Active" shows in
Output #2 Control
when this occurs.
Results
Fill Level (%)
: The percentage of volume filled within the ROI.
Peak Height (mm)
: The peak height within the ROI.
Output 1
: Varies depending on what is selected from the
Output #1 Control
list.
Discrete Out
Pulse Pro (Hz)
: The Pulse Pro frequency from 100 Hz to 600 Hz.
Not Used
Output 2
: Varies depending on what is selected from the
Output #2 Control
list. Output 2 is disabled (not used)
when the external trigger is enabled.
Discrete Out
Pulse Pro (Hz)
: The Pulse Pro frequency from 100 Hz to 600 Hz.
Not Used
ZMX Series 3D Time of Flight Sensor
16
www.bannerengineering.com - Tel: + 1 888 373 6767
