4. Tighten the mounting screws to secure the device (or the device and the bracket) in the aligned position.
Figure 5. Mounting Holes
Note:
Do not remove the housing screws.
Note:
Provide adequate dissipation of heat.
A good heat conductor, such as aluminum,
may be required.
Mounting Surface Thickness
Length of Mounting Screws
≤ 2 mm
4 mm
2 mm to 4 mm
6 mm
4 mm to 6 mm
8 mm
2.3 Wiring
To maintain the ratings listed in the Specifications, use cables with shields.
Tighten the cables finger tight only.
Figure 6. Channel 1 as PNP Output, Channel 2 as Trigger
Input
Load
12–30 V DC
Remote
Input
bn (1)
bu (3)
bk (4)
wh (2)
Figure 7. Channel 1 as NPN Output, Channel 2 as Trigger
Input
Load
12–30 V DC
Remote
Input
bn (1)
bu (3)
bk (4)
wh (2)
Figure 8. M8 Male Connector
3
2
1
4
Table 1: Power and I/O Pinouts
Pin
Wire Color
Description
1
Brown
12 V DC to 30 V DC
2
White
Trigger Input or Output (selectable PNP, NPN, or push-pull)
3
Blue
Common
4
Black
Output (selectable PNP, NPN, or push-pull)
2.4 Install the Software
Use the following instructions to install the Banner 3D Configuration software on your computer.
Important:
Administrative rights may be required to install the Banner 3D Configuration software.
1. Download the latest version of the software from
2. Navigate to and open the downloaded file.
3. Run the downloaded installer.
4. Check the agreement for license terms and conditions.
ZMX Series 3D Time of Flight Sensor
www.bannerengineering.com - Tel: + 1 888 373 6767
7
