Banner DXMR90-X1 Series, Instruction Manual

Page: 16 / 55

May 09, 2023
DXMR90-X1 Series Controller Instruction Manual
16
Follow these instructions to change the DXMR90-X1 's IP address.
By default, the DXMR90-X1 is set to a static IP address of 192.168.0.1. The IP address can be changed by using the DXM
Configuration Software and updating the XML.
After making any changes to the configuration, you must save the configuration files to your computer, then upload it to the
device.
Changes to the XML file are not automatically saved. Save your configuration file before exiting the tool and before sending
the XML file to the device to avoid losing data. If you select DXM › Send XML Configuration to DXM before saving the con-
figuration file, the software will prompt you to choose between saving the file or continuing without saving the file.
Mechanical Installation
Install the DXMR90-X1 to allow access for functional checks, maintenance, and service or replacement. Do not install
the DXMR90-X1 in such a way to allow for intentional defeat.
Fasteners must be of sufficient strength to guard against breakage. The use of permanent fasteners or locking hardware is
recommended to prevent the loosening or displacement of the device. The mounting hole (4.5 mm) in the DXMR90-X1 ac-
cepts M4 (#8) hardware. See the figure below to help in determining the minimum screw length.
Set the IP Address
Launch the DXM Configuration Software . 1.
Go to the Settings › Ethernet screen.
2.
◦
◦
In the IP Address section, select Static IP or DHCP from the drop-down list.
If Static IP is selected, enter the IP address , Subnet , and Gateway address as desired.
If DHCP is selected, the IP address , Subnet , and Gateway address are grayed out and not configurable.
Changing the IP Address to DHCP can make it so the DXM cannot be reached. Before changing this
to DHCP , you MUST have a server that is going to assign an IP Address to the DXMR90-X1 .
3.
Save your changes to the configuration file (File › Save ). 4.
Upload the configuration file to your controller (DXM › Send Configuration to DXM ).
5.
Save and Upload the Configuration File
Save the XML configuration file to your hard drive by going to the File › Save As menu.
1.
◦
◦
◦
Go to the DXM › Send XML Configuration to DXM menu.
Status indicator bar
If the Application Status indicator is red, close and restart the DXM Configuration Tool, unplug and re-plug in
the cable and reconnect the DXM to the software.
If the Application Status indicator is green, the file upload is complete.
If the Application Status indicator is gray and the green status bar is in motion, the file transfer is in progress.
After the file transfer is complete, the device reboots and begins running the new configuration.
2.
© Banner Engineering Corp.