Banner DXMR90-X1 Series, Instruction Manual

Page: 14 / 55

May 09, 2023
DXMR90-X1 Series Controller Instruction Manual
14
•
•
•
The software only loads a file to the DXM. Internal parameter settings that are changed in the tool but not saved to the file will
not be sent to the device.
Modify Multiple Registers
Modify a range of registers from the Local Registers › Local Registers in Use › Modify Multiple Registers screen.
Select which parameter fields to modify. Most parameters have three selections.
Unchanged—no changes
Default—change to default settings
Set—modify the parameter. Other selections will appear based on the parameter.
Modify Multiple Registers screen
Define an RTU Read Rule
Follow these steps to create a new read rule. This example creates a read rule to read six registers (address 1 through 6),
from Port 1 Modbus Slave 4. The results are stored in the Local Registers 1 through 6.
Enter the Starting register and Ending register .
1.
Select the value to change using the drop-down list next to each value.
2.
Enter the new value in the field provided.
3.
To push register values to the web server, set Cloud Permissions to read.
If the Cloud Permissions are set to Read, the web server only views data from the device and cannot write data to
the device. If the permissions are set to Write, the web server only writes to the device and cannot read the data. If
the permissions are set to Read/Write, the web server can read the data from the device and write to the device from
the web.
4.
Click Modify Registers to save and apply the changes.
5.
◦
◦
◦
Define the Port settings to be compatible with the connected devices.
Verify the Baud Rate and Parity match that of the connected Modbus slave devices.
The Timeout controls how long the DXMR90-X1 waits before determining a command failed to send. Set
based on the specific application requirements.
The Delay between messages defines the minimum wait time between resending another command. Set
based on the specific application requirements.
1.
Go to the Register Mapping › RTU › RTU Configuration screen.
RTU Configuration screen
a.
Go to the Register Mapping › RTU › RTU Configuration screen. b.
Modify the Port settings as needed.
c.
From the Register Mapping › RTU › RTU Read screen, click Add Read Rule . 2.
Click the arrow next to the name to display the parameters.
3.
© Banner Engineering Corp.