Dismantling, English 6.1
Dismantling
Illustrations are placed on page 6.37 – 6.38.
Contrast screen, removal
Remove the screws below the picture tube. See
21. Use one hand to push
upwards just below the Bang & Olufsen logo, and at the same time use the other
hand to carefully pull outwards at the top. Carefully remove the contrast screen.
Contrast screen, mounting
Place the contrast screen in the metal brackets in the bottom corners of the front
frame. See
22. Grib the side edges of the screen with both hands and push
inwards.
Please note
that it must be easy to push it into place. If not the contrast screen
may not be properly mounted in the metal brackets. The contrast screen might
shatter if being forced into place.
Push the contrast screen into place at the top, and gently push it down. Mount
the screws below the picture tube. See
21.
For cleaning use a mild window cleaning fluid. Make sure no streaks or traces are
left on the screen or picture tube. Make sure that no moisture is left between the
contrast screen and the front frame.
Mains Distribution, PCB60 (with mains voltage fuse)
Remove the bottom section of the rear panel by loosening four screws. The black
plastic box containing PCB60 can now be opened.
Cloth front
Insert a screwdriver at the center just below the cloth front (K) and wriggle up the
cloth front without damaging strip or cloth front. Push the cloth front to the right,
about one cm. Then pull out the cloth front carefully. See
21.
For mounting of the cloth front, hold it straight onto the TV, placing it just a little
to the right. Make sure the clips fit into the holes in the TV. Then carefully push it
to the left to make it fit on the TV. It is easily felt if it has been misplaced.
Speaker cabinets
Remove the upper rear panel (6 screws). Remove the lower rear panel (4 screws).
Remove the speaker front fabric. Remove the screw at the top of the speaker cabinet,
as viewed from the front. The speaker cabinet can now be pulled backwards.
When installing the speaker cabinet, the two rubber dampers must be fitted on
the towers at the bottom of the speaker cabinet, and they must be fitted into the
holes in the bottom of the main frame.
Motorized stand
Carefully place the BeoVision Avant 32 DVD on its side.
Remove the 4 pieces of tape covering the holes in the bottom of the motorized
stand. Turn the motorized stand until the 4 holes in the bottom are aligned with
the screws. Unscrew the 4 screws to remove the motorized stand.
The aluminium sheet on the motorized stand is fixed with double-sided adhesive
tape.
STATIC ELECTRICITY
MAY DESTROY THE
PRODUCT
ABO-CENTER
v/HENRIKSENS
ELEKTRONIK
