B&K 2250 Light, User Manual, Page: 84 / 208

74
2250 Light – User Manual
Table 8.2
Content of Notification
Note: some of the information listed above may not be available, depending on the conditions
when the notification was sent, e.g., no measurement values will be available immediately after
a power on.
8.4.2 Text/SMS Notifications
Notifications via SMS (text message) can be used if you have connected a
GSM/GPRS/EDGE/HSPA modem to the analyzer (see section 8.2.2) and set
Modem to
Disabled (a text message cannot be sent if the modem is set to GPRS/EDGE/HSPA Dialup ).
In addition to sending SMS notifications initiated by alarms, you can send an ‘INFO’ SMS to
the analyzer and ask for an SMS notification, after which you will get a notification within 30
seconds.
You need to setup a Phone Number in Preferences , Notifications , SMS and set Active to Yes for
the SMS. You can also add a Name for the number for easier identification.
You can setup two individual SMS phone numbers for sending the SMS notification to two
recipients.
Set Notification to SMS and a notification will be sent by SMS to the active phone numbers,
when any of the alarm conditions are met, or if the analyzer receives an ‘INFO’ SMS.
You can test the system by tapping on the Main Menu icon and selecting “ Send
Notification via SMS ”.
Note 1 : Two to three text messages will be used to send the complete notification – depending
on the content and language settings.
Note 2 : Text messages cannot be sent or received while the analyzer is connected to BZ-5503
or On-line display.
Information Type Content
Reason for notification ‘ Test ’, ‘ Alarm ’ or ‘ Status ’ followed by a short description
Time of notification Date and Time
Instrument ID Serial No . and Location
Status of current Disk Free memory / Total memory
Status of Internal Battery Full , High , Low , Critical , Charging or Unknown
Measurement Status (if available) Running , Paused or Stopped
Latest CIC Result (if available) Passed , Background noise too high , Ratio outside tolerances ,
Ratio deviates from Ref ., Undefined Ref. , or Undefined
Current value of LAF (if available) The value