Bandai Namco Time Crisis 5, Operation Manual, Page: 47 / 194

7. Operation
47
1
2
3
4
5
6
7
8A
8B
9
10
11
Operation
Tro
ub
les
ho
otin
g
Test Mode Test Mode
(1) SIGHT CALIBRATION (Gun Sight Calibration Screen)
This screen is used to calibrate the gun sight of the gun assembly.
1
Press the Service switch in the GUN TEST screen to display the SIGHT CALIBRATION screen.
SIGHT CALIBRATION screen
Gun cursor
(a) Message display
Calibration gun sights
(in the actual screen,
only one of them appears
at a time)
2 The gun controller is calibrated by shooting eight calibration gun targets in order from
the upper left to upper right (four positions), and from the lower left to lower right (four
positions).
Move the gun cursor to aim at the indicated calibration gun target and pull the trigger.
When the shot position is further away than a designated distance from each gun target,
OUT OF AREA appears.
When you shoot outside the screen or a position a certain distance away from each gun
target, RETRY appears and an error beep sounds. If this occurs, you cannot move to the next
gun targets.
3
Press the Enter switch to discard the calibrating data and return to the GUN TEST screen.
4 Set the Test switch to OFF during calibration to discard the calibrating data and return to the
game.
5 When all of the eight calibration gun targets are shot, FINISHED appears at (a) and the gun
controller calibration data is saved, after which the display returns to the GUN TEST screen.