Bandai Namco Time Crisis 5, Operation Manual, Page: 103 / 194

8B. Service
103
- Must be performed by a technician -
Test Mode
Tro
ub
les
ho
otin
g
1
2
3
4
5
6
7
8A
8B
9
10
11
Service
(9) Replacing the USIO (T) PC board
* This section explains the procedure applicable to the monitor tower (L) assembly. Repeat the procedure
for the monitor tower (R) assembly.
●
In order to avoid electric shock, accident or injury to yourself or others as well as damage to the
electronic circuits, be sure to turn off the power switch before starting this task.
WARNING
●
PC boards are vulnerable to static electricity. If a person handles a PC board while charged
with static electricity, the parts on the PC board may be damaged. Before handling a PC
board, discharge the static electricity from your body by touching the surface of grounded
metal.
1 Turn off the power switch.
(See P-81 "8A-8 Turning the Power Switch On".)
2
Remove the back panel from the rear side of the monitor tower (L) assembly.
(See step
2
in P-101 "(8) Replacing the AMP PC board".)
3
Disconnect the four connectors, remove the four Phillips pan head screws (with flat and
spring washers) (M3 x 8), and remove the USIO (T) PC board.
Phillips pan head screw (with flat and spring washers) (M3 x 8)
Phillips pan head screw
(with flat and spring washers)
(M3 x 8)
Phillips pan head screws
(with flat and spring washers)
(M3 x 8)
Connectors
Connectors
USIO (T) PC board
4
To install, perform the procedure in reverse.
●
When installing, be sure to securely lock the connectors.
●
When installing, take care not to allow the connectors and harnesses to get caught.
●
When removing, be careful not to damage the PC board and other parts.