Balluff IO-Link BLA D Series, User Manual

Page: 29 / 48

www.balluff.com 5 english
1.5 Laser class
This device is laser class 1. It is certified according to
DIN EN 60825-1:2015-07.
The laser source inside the sensor housing is class 3. The
sensor housing is completely sealed and the laser light is
attenuated by the optics inside so that only radiation of
class 1 can be emitted. The laser emission wavelength is
650nm (red light). The laser works with pulsed operation
(1:1 on/off ratio). The pulse duration is between 0.5 ms
and 2.5 ms. The typical output power in the laser pulse
depends on the size:
BLA version Output power
BLA 100D 100 µW
BLA 72D 130 µW
BLA 50D 180 µW
BLA 32D 240 µW
Tab. 1-2: Output power
1.6 Approvals and markings
The CE symbol confirms that our products comply
with the requirements of the current EU directive.
More detailed information on the guidelines,
approvals, and standards is included in the
declaration of conformity.
1.1 About this guide
This manual contains operating instructions and technical
documentation for the emitter and receiver of all Balluff Light
Arrays of series D. A distinction is made between the stan-
dard version with analog and switching outputs and the
IO-Link version:
Standard version IO-Link-version
BLA 100D-001-S115 BLA 100D-002-S4
BLA 72D-001-S115 BLA 72D-002-S4
BLA 50D-001-S115 BLA 50D-002-S4
BLA 32D-001-S115 BLA 32D-002-S4
Tab. 1-1: BLA versions
All specifications in this operating manual, especially the
safety instructions, must be strictly observed.
The guide is intended for qualified technical personnel.
Read this guide before you install and operate the Light
Array. This manual is to be stored so that it is always
accessible.
1.2 Organization of the guide
The guide is organized so that the sections build upon
each other.
– General
– Installation
– Startup
– Functions
– Displays IO-Link parameters
– Technical data
The detailed structure can be seen from the Table of
Contents.
1.3 Symbols and conventions
Note, tip
This symbol indicates general notes.
1.4 Scope of delivery
– Emitter
– Receiver
– Montagehalter
– User's guide
– Connection cable emitter to receiver (length 3 m, 4-pin,
M12 male to M12 female)
– In the standard version additionally a connection cable
(length 5 m, 8-pin, socket M12 on open cable ends)
1
Notes to the user
BLA Series D
Balluff Light Array