Balluff BOS R254K-UUI-LH10-S4, Manual

Page: 118 / 196

20 english
3.6 Events
Event Code Event Type Description Device Status
0x1850
(6224)
Notification Process data profile selection cannot be used –
default value is used.
0 – Device is operating properly.
0x1851
(6225)
Notification Process Data Update Timeout – for information
purposes only
0 – Device is operating properly.
0x1852
(6226)
Warning Multiple Process Data Update Timeout – for
information purposes only
0 – Device is operating properly.
0x1860
(6240)
Warning Warning about service life of transmitter.
►
Replace sensor during next maintenance cycle.
1 – Maintenance-Required
0x4000
(16384)
Error Temperature fault – overload – The device is
operated outside of the device-specific temperature
limits. Risk of device damage.
4 – Failure
0x4210
(16912)
Warning Device temperature overrun – clear heat of source
– risk of device damage. The device is too hot.
►
Remove heat source, provide the device with
heat insulation if necessary.
2 – Out-of-Specification
0x4220
(16928)
Warning Device temperature underrun – insulate device – risk
of device damage. The device is too cold.
►
Insulate the device.
2 – Out-of-Specification
0x5110
(20752)
Warning Primary supply voltage exceeded
►
Check for deviations in the supply.
2 – Out-of-Specification
0x5111
(20753)
Warning Primary supply voltage below minimum value
►
Check for deviations in the supply.
2 – Out-of-Specification
0x8CD0
(36048)
Warning Inclination alarm
►
Check installation.
1 – Maintenance-Required
0x8CD1
(36049)
Warning Vibration alarm
►
Check machine.
0 – Device is operating properly
0x8CFF
(36095)
Warning Low signal quality level
►
Check alignment of sensor
►
Clean sensor
0 – Device is operating properly.
0x8D07
(36103)
Warning The calculation of the basic statistics was stopped
automatically to avoid a buffer overflow.
0 – Device is operating properly.
0x8D08
(36104)
Warning Speed value is below the limit. 0 – Device is operating properly.
0x8D09
(36105)
Warning Speed value is above the limit. 0 – Device is operating properly.
0x8D0B
(36107)
Warning Overload or short circuit at pin 2
►
Check wiring.
2 – Out-of-Specification
0x8D0D
(36109)
Warning Incorrect load/cable breakage, analog current output
pin 2
►
Check wiring or connected devices.
2 – Out-of-Specification
0x8D0E
(36110)
Notification The time has elapsed. This event reports the timeout
of the minimum value/maximum value/average
calculation.
It does not report a timeout for the calculation of the
moving average because the timer repeats and it
does not indicate the end of the calculation.
0 – Device is operating properly.
0x8D10
(36112)
Warning Device temperature upper warning – The set upper
temperature warning threshold has been exceeded.
0 – Device is operating properly
3
Overview of IO-Link Data and Functions (continued)
BOS R254K-UUI-LH10-S4
Photoelectric Sensors