Bale Band-It GFC 100, Operator'S Manual

Page: 84 / 108

Operator’s Manual 79
is still displays “069”. If it does, lightly tap the switch on something to free up the
stuck switch. The switch may need to be replaced if this problem continues.
- If the Right Bander cylinder is partially retracted,
- Check that a foreign object is not preventing the Right Bander cylinder from
retracting.
- Electric power or hydraulic power or hydraulic return has been disconnected or
shut off from machine.
- If the Right Bander cylinder is still extended,
- Check that hydraulic power is still on to the machine and that return line is still
connected.
- Check that a foreign object is not preventing the Right Bander cylinder from
retracting.
- Check that the directional valve is not stuck.
070 Timer Delay Error
- Disengage hydraulic power and unplug main power cord. Wait for approximately 10
seconds, plug back in and engage hydraulic power.
071 Communication from Band Computer
- Disengage hydraulic power and unplug main power cord. Wait for approximately 10
seconds, plug back in and engage hydraulic power.
- On Line 3 of Display Monitor, if the number after the dash is 0, then disconnect main
electrical and hydraulic power. Open the plastic computer box in the banding box and
unplug the two 10 amp fuses. Reconnect main electrical power only. Wait
approximately 10 seconds and then reinstall the two 10 amp fuses at the same time.
Recheck number on Line 3 after the dash, it should then be 1. Apply hydraulics.
072 Waiting for Left Band Out reed switch to be on.
Note: After the machine has raised the Right/Left Bander cylinders, the Left Band Out
reed switch should be lined up with the Left Band magnet, which turns the switch on.
This is what the machine is waiting for.
- If the Left Bander cylinder is fully extended,