Bale Band-It GFC 100, Operator'S Manual

Page: 60 / 108

Operator’s Manual 55
028 Waiting for Strap Guides to be at top position
Note: The machine has turned on the Strap Guide Arms motor and sent them up. When
the Strap Guide Arms magnet reaches the Bale Position 0 sensor bar switch, the
machine stops the motor. The machine is waiting for the magnet to reach the Bale
Position 0 sensor bar.
The switch is located upper mid way of the sensor bar at the
brown mark.
- Check that Strap Guide Arms are in time with each other. They should be the same
height. If their heights vary ½ inch (12.5 mm) or greater then they are at least one
gear tooth out of time. A quick way to check their heights is to compare the distance
between the Vertical Plunger plates to the Strap Guide plates. The right side should