Baldor NXE100-1608Dx, Installation Manual

Page: 13 / 114

www.baldormotion.com
Basic Installation 3-1 MN1941
3.1 Introduction
You should read all the sections in Basic Installation .
It is important that the correct steps are followed when installing the NextMove e 100.
This section describes the mechanical installation of the NextMove e 100.
3.1.1 Location requirements
You must read and understand this section before beginning the installation .
To prevent equipment damage, be certain that input and output signals are powered
and referenced correctly.
To ensure reliable performance of this equipment be certain that all signals to/from
the NextMove
e 100 are shielded correctly.
Avoid locating the NextMove e 100 immediately above or beside heat generating
equipment, or directly below water steam pipes.
Avoid locating the NextMove e 100 in the vicinity of corrosive substances or vapors,
metal particles and dust.
The safe operation of this equipment depends upon its use in the appropriate environment.
The following points must be considered:
H
The NextMove e 100 is designed to be mounted indoors, permanently fixed and located.
H
The NextMove e 100 must be secured by the slots in the metal base.
H
The NextMove e 100 must be installed in an ambient temperature of 0 °C to 45 °C (32 °F to
113 °F).
H
The NextMove e 100 must be installed in relative humidity levels of less than 80% for
temperatures up to 31 °C (87 °F) decreasing linearly to 50% relative humidity at 45 °C
(113 °F), non-condensing.
H
The NextMove e 100 must be installed where the pollution degree according to IEC664 shall
not exceed 2.
H
There shall not be abnormal levels of nuclear radiation or X-rays.
3
Basic Installation
3
NOTICE
NOTICE
NOTICE
NOTICE