Baldor NXE100-1608Dx, Installation Manual

Page: 103 / 114

www.baldormotion.com
Accessories A-1 MN1941
A.1 Cables
A.1.1 Feedback cables
The Baldor cables listed in Table 4 connect the ‘Encoder Out’ signal from a drive amplifier (for
example MicroFlex, FlexDrive
II
, Flex+Drive
II
or MintDrive
II
), to the ‘Enc0’, ‘Enc1’ and ‘Enc2’
encoder input connectors on the NextMove e 100. One cable is required for each servo axis. See
section 4.4.1 for the connector pin configuration.
Cable assembly description Baldor catalog number
Length
Cable assembly description Baldor catalog number
m ft
Drive amplifier to NextMove e 100
feedback cable,
with 9-pin D-type male connectors
at both ends
CBL015MF-E3B*
CBL025MF-E3B
CBL030MF-E3B*
CBL050MF-E3B
CBL061MF-E3B*
CBL075MF-E3B
CBL091MF-E3B*
CBL100MF-E3B
CBL150MF-E3B
CBL152MF-E3B*
CBL200MF-E3B
CBL229MF-E3B*
1.5
2.5
3.0
5.0
6.1
7.5
9.1
10
15
15.2
20
22.9
5
8.2
10
16.4
20
24.6
30
32.8
49.2
50
65.6
75
* Available in North and South America only.
Table 4 - Drive amplifier to NextMove e 100 feedback cables
If you are not using a Baldor cable, be sure to obtain a cable that is a shielded twisted pair
0.34 mm
2
(22 AWG) wire minimum, with an overall shield. Ideally, the cable should not exceed
30.5 m (100 ft) in length. Maximum wire-to-wire or wire-to-shield capacitance is 50 pF per
300 mm (1 ft) length, to a maximum of 5000 pF for 30.5 m (100 ft).
A.1.2 Ethernet cables
The Baldor cables listed in Table 5 connect NextMove e 100 to other EPL nodes such as
MicroFlex e 100, additional NextMove e 100s, or a host PC. The cables are standard CAT5e
‘crossover’ Ethernet cables:
Cable assembly description Baldor catalog number
Length
Cable assembly description Baldor catalog number
m ft
CAT5e Ethernet cable CBL002CM-EXS
CBL005CM-EXS
CBL010CM-EXS
CBL020CM-EXS
CBL050CM-EXS
CBL100CM-EXS
0.2
0.5
1.0
2.0
5.0
10.0
0.65
1.6
3.3
6.6
16.4
32.8
Table 5 - Ethernet cables
A
Accessories
A