2-2 Installation
Terminal Access Cover Removal
To remove the Terminal Access Cover insert a small blade
screwdriver into the slots located on the lower left and right hand
corners of the access cover. Use a slight twisting motion while
lifting upward to loosen one side. Use the same motion to
loosen the other side then lift the cover off of the control. To
reinstall, simply snap the cover back into place. See Figure 2-1
below.
Figure 2-1
Summary of Contents for ID10101-E
