C.7 Exiting the site edit menu
After leaving the global submenu, PanaView returns to
the site edit menu. Click [close] to exit the site edit menu.
Then proceed to
Chapter 3, Operation
, of the
Startup guide
for instructions on taking measurements, or refer to the
appropriate chapters of this manual for detailed instructions
on using the other features of the XGF868i flow transmitter.
C.7.0a Activating security in the global menu
In order to prevent unauthorized tampering with the
flowmeter’s programming, the XGF868i is equipped with
a security feature that locks all the keys except [prog]
(which, when pressed, requires the password).
When the system is locked, access to the menus will
be denied unless the correct password is entered. The
XGF868i is shipped with a default password (2719 and
three spaces). For increased security, the default
password should be changed.
NOTE:
Once the system has been locked, it can only be
unlocked by entering the password, because access to
the
secur
submenu is restricted.
While completing these instructions, refer to the menu map
in
.
1. In the
site data menu
, double-click on the global entry.
If the system is unlocked, the window appears similar
to
Figure 46
below. Highlight and double-click on the
security option in the center pane.
Figure 46: Global menu with security option highlighted
2. If the system is locked, the window is similar to
Figure 47
below.
Figure 47: Password window
3. Enter the current or default password and click
[next item].
Figure 48: Entering password
4. At the lock out prompt, click UNlck to unlock the
system and return to the initial
program
menu, or
click
lock
to lock the system.
5. At the edit password prompt, click
no
to leave the
password unchanged, or click
yes
to enter a new
password.
IMPORTANT
Since the default password is printed in this manual, a new
password should be entered. If the password is ever lost,
contact the factory for assistance.
6. Enter the new password and click yes. Any combination
of letters and numbers up to a total of 7 characters may
be used as a password.
7. Verify the new password by re-entering it and click yes.
Be sure to record the new password in a safe place.
C.8 Exiting the site edit menu
After leaving the global submenu, PanaView returns to the
site edit menu
. Click [close] to exit the site edit menu. Then
proceed to
Chapter 3, Operation
, of the
Startup guide
for instructions on taking measurements, or refer to the
appropriate chapters of this manual for detailed instructions
on using the other features of the XGF868i flow transmitter.
75
Summary of Contents for DigitalFlow XGF868i
