Baker Hughes DigitalFlow XGF868i, Programming Manual

Page: 77 / 100

C.6.2c Setting up option cards
The XGF868i has two built-in analog outputs, which are
assigned to slot 0. Also, a variety of input/output option
cards may be installed in slot 1. See Chapter 1, Installation ,
of the Startup Guide for a complete description of the
available option cards.
To access this submenu, double-click on the
options
entry in the input/output submenu. This menu option is
used to set up and/or scale the inputs and outputs. To
accomplish this, complete the following steps:
• Double-click on the desired
I/O slot to program the I/O
functions in that slot.
NOTE: If an option card is not installed in slot 1 , the slot1
option does not appear at the above prompt.
Proceed to the appropriate section for programming
instructions specific to the type of input or output
selected above.
Analog outputs
Complete the following steps to set up the analog outputs
for any slot (refer to Figure 58 on page 83 ):
1. Double-click on the desired output (A or B).
NOTE: The set up of output A is used here as an example.
Identical procedures would be used to set up output B.
2. Double-click on off to disable output A and return to
step 1, or on 0-20 mA or 4-20 mA to specify the desired
range for output A.
3. Double-click on the desired channel option. See Table 24
below for a description of the channel options available.
Table 24: Channel options
Option Description
Channel 1 Channel 1
Channel 2 Channel 2
Add channels CH1+CH2
Subtract channels CH1-CH2
Average channels (CH1+CH2)/2
4. Double-click on the desired measurement name .
( Table 25 on page 68 provides a description of the
available parameters.)
NOTE: All the options shown below will appear only if
mass flow is activated.
67