Baileigh SS-2822, Operator'S Manual

Page: 51 / 64

48
48
TROUBLESHOOTING
Trouble Possible Cause Remedy
Shaper will not
start.
1. Cord unplugged from the power
source.
2. Fuse blown or circuited breaker
tripped.
3. Cord damaged.
4. Reversing switch is in the Off
position.
5. Overload tripped.
6. Cabinet door is open. 1. Plug in power cord.
2. Replace fuse or reset circuit
breaker.
3. Replace cord.
4. Turn switch to forward of reverse.
5. Reset overload by depressing red
stop button.
6. Close cabinet door.
Overload kicks
out frequently.
1. Extension cord or wiring
inadequate size.
2. Feeding stock too fast.
3. Cutter needs cleaning or
replacing.
See also Unsatisfactory Cuts below. 1. Replace cord or wiring with proper
gauge wire.
2. Reduce feed stock rate.
3. Clean or replace cutter.
Cuts are
unsatisfactory.
1. Dull cutter.
2. Cutterhead rotating in wrong
direction.
3. Feeding work in wrong direction.
4. Gum or pitch on cutter.
5. Gum or pitch on table causing
erratic feed. 1. Replace cutter.
2. Check for proper rotation at
startup.
3. Feed work against the cutter
rotation.
4. Remove cutter and clean with
solvent.
5. Clean table with solvent.
Cutter does not
come up to full
speed.
1. Shop wire gauge is too small.
2. Extension cord or wiring
inadequate size.
3. Power source is not adequate.
4. Motor not wired for correct
voltage.
5. Spindle is locked with mandrel
lever. 1. Replace wiring with proper gauge
wire.
2. Replace with adequate size cord.
3. Contact your electric utility.
4. Refer to motor name place and
wiring diagram for correct wiring.
5. Unlock spindle
– see label next to
lever on base.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.