9
9
28.
Maintain machine in top condition
. Keep clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
29.
Reduce the risk of unintentional starting
. Make sure switch is in
“OFF”
position before
plugging in power cord.
30.
Never leave machine running unattended. TURN POWER OFF
. Don’t leave machine until
it comes to a complete stop.
31.
DO NOT Perform Any Operation Freehand.
Use the fence for straight shaping, the miter
gauge for end shaping, and a starting pin and collar for curve shaping.
32.
Push Blocks.
Push blocks or push sticks should be used in situations where it is necessary
to push the piece part against the fence.
33.
AVOID
awkward operations and hand positions where a sudden slip could cause your hand
to move into the spinning cutter causing
serious personal injury
.
34.
Cutter Height.
Keep any unused portion of the shaper cutter below the surface of the table.
35.
Sand Appropriate Material.
Only use this spindle shaper sander for natural wood stock. It is
NOT
recommended to sand particle board, plastics, laminates, medium-density fiber board
(MDF), metal, glass, ceramics, or products containing asbestos or lead paint. Some of these
materials contain hazardous dust and will shorten the life span of the sanding spindle.
36.
Warning
: The dust generated by certain woods and wood products can be injurious to your
health. Always operate machinery in well-ventilated areas and provide for proper dust
removal. Use a wood dust collection system whenever possible.
SAFETY: SPECIFIC RULES
READ THE MANUAL. Know the limitations and hazards in using the shaper. One SAFETY rule
decal and one DANGER decal are placed on each machine as reminders of good safety
practice.
SHORT STOCK. Never shape stock less than 12 inches in length without special fixtures.
Where practical, shape longer stock and cut to size.
12 INCH RULE. When shaping, never allow your hands to come closer than 12 inches to the
cutters.
HAND SAFETY. Never pass the hands directly over, or in front
of, the cutters. As one hand approaches the 12 inch radius
point, remove it (or the push stick) in an arc motion and
reposition hands 12 inches beyond the cutters (Figure 1).
Summary of Contents for SS-2822
