35
35
EDGE SHAPING: LONG BOARDS
When edge shaping long boards, the work piece must be at least 12 inches long.
1. Use the hold-ins and hold-downs as shown in
figure 13 to firmly hold the work piece down and
against the fence. If work piece is too wide for the
hold-ins to be used, clamp a scrap board to the
table to substitute for the hold-ins.
2. Check the rotation of the cutter. Be sure to feed
workpiece against rotation of the cutter.
3. Feed the workpiece slowly and steadily with firm,
even pressure to make a smooth cut.
Note:
The rate of feed depends on depth of cut and experience of operator.
EDGE SHAPING: SHORT BOARDS
When edge shaping short boards, never attempt to hand
guide any stock less than 12 inches long, or narrower than
3 inches without the use of a special guide as shown in
Figure 14.
Summary of Contents for SS-2822
