42
42
In many situations the workpiece is positioned against the
template using dowels as anchor points and handles
(wood blocks) to assist the operator in guiding the
workpiece through the cut as shown in Figure 31.
HORIZONTAL TOGGLE CLAMP
The horizontal toggle clamp, similar to those illustrated in
Figure 32, is especially useful when ordinary “C” clamps will
not allow the freedom of movement often required in shaping.
The toggle clamp also allows the operator to firmly control the
workpiece without the additional pressure required to keep
workpiece and template together by hand. Anchor points,
such as dowels, are required with this type setup.
SPECIAL CUTS
The illustrations in this section shown the profile, or section, views made by the cutter(s). The
most efficient cutters are carbide tipped to ensure clean and long-term cutting. Small cutters
may be solid carbide, and some use inserts. Since there are such a wide variety of choices, the
operator is limited only by his experience and imagination.
STACKED CUTTERS
In addition, a variety of interesting and timesaving cuts can be
made in a single setup by stacking the cutters as shown in
Figure 33. When the operator stacks the cutters, extra care
should be taken to see that all parts are clean, free of nicks
and flaws, and perfectly balanced in the stacked position.
Summary of Contents for SS-2822
