Baileigh SS-2822, Operator'S Manual

Page: 26 / 64

23
23
4. Repeat steps 3 to attach the remaining fence
half.
5. Attach Guard Mounting Bracket (F) to the red top
Cover with knob (G, Fig. 16).
6. There are several types of guards that should be
attached to the shaper fence depending on the
operation that you are performing. The Hold
down Bracket (I), the Chip Deflector (H), and the
Overhead Guard (J) are attached to the Fence
Assembly. (Fig. 16)
Fig. 16
Dust Collection
It is recommended that you use a dust collector (not included) when
using this machine. The minimum air flow requirements for this machine
are listed below. The machine comes with a 4” dust port located on the
side of the machine.
Fig. 17
The dust extraction equipment is to be switched on before commencing machining.
Air current speed is 20m/s for vacuum suction dust emission index.
When air current speed of dust collector device (in accordance with EN12779:2004) is not lower
than 20m/s, ensure machine can be normal exhausted. User must wear dustproof mask.
1. Required air flow: 1500 m3/h.
2. Ensure pressure drop of each dust collector outlet carrying air current speed: 1100Pa.
3. Wind speed of dust collector tube m/s:
Dry Chips: 20m/s,
Wet chips: 28m/s (water content is equal to18%)