Baileigh Industrial CS-350EU, Operator'S Manual

Page: 26 / 60

23
23
OPERATION SETUP
Miter Angle
1. Push the miter lock lever (A) to the left to release
the disk head and vise assembly.
1. Rotate the disk head assembly to the desired miter
angle.
2. Use the indicator scale (B) to set the desired cut
angle. (Fine tune the angle as needed to get the
exact angle.
3. Slide the vise assembly forward or aft as needed
to provide clearance for the cutting blade.
4. Adjust the vise clamping jaw (C) to allow for the
blade to clear the vise without contacting the jaw.
5. Loosen the clamping bolt (D) and slide the jaw left
or right as needed to clear the saw blade. The jaw
should be between 0.25” and 0.5” (6 – 13mm) with
out contacting the saw blade.
6. Adjust the clamping support to the right side of the
blade by loosening and the mounting bolt and
sliding the support within the slots (E) or when
needed, changing the slots. If necessary, the
clamping support may be removed.
7. Pull the miter lock lever (A) back to the right to lock
in the angle. ALWAYS LOCK THE LEVER
BEFORE CUTTING.
CAUTION:
Check that the cutting blade clears all parts of the vise
assembly before cutting. The blade can strike and damage parts of the vise assembly
(especially during miter cuts) if not properly adjusted.
A
B
D
C
E