19
19
Attach the feed handle to the head assembly.
•
Insert the threaded end of the feed handle (
E
) into the
gear oil fill hole (
F
).
•
Turn the handle clockwise (
cw
) until tight so that the
trigger switch (
G
) points up.
•
Tighten jam nut clockwise (
cw
).
Connect feed handle cable to motor box.
•
Route the feed handle cable over the transfer case to the
electrical box on the motor.
•
Plug the feed handle cable connector (
H
) into the open socket.
•
Tighten the connector nut.
Attach the support roller to the left side of the base.
•
Place the support roller (
I
) up to the machine base and align
the 2 slots (
J
) with the screw holes in the base.
•
Using (2) M10 washers and (2) M10x25 hex bolts, attach the
support roller to the base.
•
(
DO NOT
Tighten).
•
Place a level across the mouth of the vise and the top of the
roller. Raise or lower roller (
I
) until level, then secure by
tightening bolts.
Attach the bar stop to the vise.
•
Verify set screw (
K
) is loose enough not to interfere with the
mounting hole on the side of the vise.
•
Insert the collar on the long rod (
L
) into the side of the vise
until snug making sure graduated scale can be easily read.
•
Tighten the set screw (
K
) to secure the bar stop.
H
E
F
G
J
I
K
L
Summary of Contents for CS-350EU
